Total RNA isolated from yeast cells was prepared as described by Sherman et al. [1986], but using a multiple-sample automated device (Fast-Prep, BIO101) to break the cells. Sherman F, Fink GR, Hicks JB (1986) Methods in yeast genetics. Spring Harbor Cold Laboratory Press, Cold Spring Harbor, New York.
Label
33P
Label protocol
In vivo labeling by run-on (GRO) was done using 33P-UTP. Around 6 x 10exp8 yeast cells were used to perform in vivo transcription. After spinning down cells, they were permeabilized with 20 mL of 0.5% sarkosyl and cells were recovered by low-speed centrifugation and the supernatant was removed. In vivo transcription was performed by resuspending cells in 115 µl of RNA water and adding 162 µL of Run On Mix (120 µl of 2.5x transcription buffer [50 mM Tris-HCl pH 7.7, 500 mM KCl, 80 mM MgCl2], 20 µl of AGC mix [10 mM each of CTP, ATP and GTP], 6 µl of DTT [0.1 M] and 13 µl of [α-33P]UTP [3000 Ci/mmol, 10 Ci/µL]). The mix was incubated for 5 minutes at 30ºC to allow transcription elongation. The reaction was stopped by adding 1 ml of cold distilled water to the mix. After the RNA extraction by the acid-phenol protocol, the RNA was partially fragmented by adding 10 µl of cold NAOH 0.2M to each sample at a final concentration of 50mM and incubating for 5 minutes on ice. Fragmentation was stopped by adding 10 µl of cold HCl 0.2M. The genomic DNA labeling was done with 500 ng of yeast genomic DNA using the Random Primers DNA Labeling System (Invitrogen cat. nº 18187013), following the manufacturer instructions.
Hybridization protocol
Hybridization Solution was: 0.5M Na-Phosphate buffer, 1mM EDTA and 7% SDS, pH 7.2. The hybridization protocol used was as follows. Filters were inserted in 12.5X 2.5-cm flat-bottom plastic tubes and pre-hybridized in a rotator oven with 5 ml pre-hybridization solution (the same as used for hybridization but without the radioactive sample) at 65ºC. The pre-hybridization solution was then d with 5 ml of the same solution containing 1-5X10exp6 dpm/mL of radioactive sample and hybridized for 48h. Washing conditions were: 20 min at 65ºC in 1X SSC, 0.5% SDS, and twice at 65ºC for 10 min in 0.5X SSC, 0.1% SDS.
Scan protocol
Images were acquired using a FujiFilm FLA3000 Phosphorimager. After the washing step, membranes were kept humid, sealed in Saran wrap, avoiding any bubbles, and exposed to an imaging plate (BAS-MP, FujiFilm) for various times. After scanning, filters were stripped by washing them twice with boiling stripping buffer (5 mM sodium phosphate, pH 7.5, 0.1% SDS) over the membrane and left to cool at room temperature. To ensure that radioactivity had been eliminated, the filters were checked with a Geiger counter.
Description
gDNA 3_5 F6 Random priming gDNA hybridization on macrochip F6.
